Single story ranch house with solar panels on a shingle roof, a worker seen from behind rinsing them with a soft brush on a long pole, hazy mountains behind

Gentle solar panel cleaning for homes in California

TLW Solar Panel Cleaning LLC rinses rooftop, backyard and patio-cover arrays with purified water and soft brushes, across the San Gabriel Valley in Los Angeles County and nearby communities.

What settles on the glass here

Solar glass in this part of California rarely gets truly dirty. It gets dull. A thin layer of valley haze, a dusting of pollen in spring and a gray film at the end of a dry summer all settle onto the panels a little at a time, and a light rain in winter only moves them around.

Clean glass lets more sunlight reach the cells, and it simply looks better from the street and the yard. The trick is to remove that layer without harming the glass or its coating. That is why we compare methods openly, choose the gentlest one that works and explain the choice to you.

Corner of a rooftop solar panel dulled by dust, yellow pollen and a few dried bird droppings, low ranch roofs behind
  • Haze and road dust

    A fine gray layer that builds up slowly, most of all near busy streets and freeways.

  • Spring pollen

    A yellow dusting from olive, oak and pepper trees that turns sticky with morning dew.

  • Bird spots

    Dried droppings on the upper rows, where birds rest on the roof ridge.

  • Ash and soot film

    A greasy gray film after smoke season that smears if it is wiped dry.

Two ways to clean the same panel

Choose any two approaches and watch the rows change. The first column starts with our usual visit; the second starts with the tool we keep away from solar glass.

First approach
Compare with
Point of comparison Pure-water brush cleanWe use itPurified water through a long pole and a soft brush, then a clean rinse that dries without spots. Pressure washerWe avoid itA high pressure jet aimed at the glass and frame.
What it removesValley haze, road dust, pollen and most dried bird spotsLoose dust, but it tends to push grime into edges instead of lifting it
Kindness to the glassVery gentle. Soft bristles and plain water onlyHarsh. Force on the glass, seals and frame edges
Water useModerate. A slow, steady flow of filtered waterHigh. A lot of water in a short time, often tap water that leaves spots
When it fitsMost rooftop, backyard and patio-cover arrays, most of the timeNot for panels. We keep pressure washers off solar glass

Read the full methods comparison

How a morning visit goes

Most cleanings are done before the day gets warm. Here is the order things happen in, from the message the day before to the note we leave when we finish.

  1. We confirm the morning

    You get a short message the day before with the time we expect to arrive and what to leave open, such as the side gate.

  2. Set up and look

    We roll out hoses along paths, connect the purified water unit and walk around the array to see what has settled on it.

  3. Brush and rinse

    Each row is brushed with soft bristles and purified water, then rinsed from the top edge down. Stubborn spots get a gentle second pass.

  4. Final pass and tidy up

    A last pure-water rinse dries clear. Hoses are coiled, drips are wiped and the yard is left as we found it.

  5. A short note to you

    We tell you what we cleaned and anything unusual we noticed along the way, such as a cracked panel or a branch over the array.

Soft pale brush moving over wet dark solar glass with a palm tree reflected in it

Where we work

Our base is on the southern side of the valley, and we clean arrays on homes across the San Gabriel Valley in Los Angeles County and nearby communities. Most mornings we are on low ranch roofs, clay tile roofs and the occasional flat mid-century roof, with the mountains to the north and haze sitting low over the valley floor.

Send your ZIP code with your request and we will confirm whether your home is in our usual area. Weekday and Saturday mornings are open for visits.

About the company

Questions people ask first

Short answers here, and more on the questions page.

Why not a pressure washer?

Too much force on thin glass, seals and frame edges, and usually tap water that leaves spots. We use purified water and soft brushes instead.

Do you use chemicals?

No harsh chemicals. Most visits use only purified water. A small amount of mild soap is used for stubborn film and is rinsed off completely.

Do I need to be home?

Not always. If we can open the gate and reach a water spigot, many visits happen while you are out. We send a short note when we finish.

How long does it stay clean?

It depends on the trees, the roads and the season around your home. Glass usually stays clear for months, then dulls a little at a time.

Ready for clear glass?

Tell us where the panels sit and what you see on them. We reply during office hours and set a morning that suits you.